Assembly categories
Filter Brakes Suspension Steering Cooling/Air Conditioning Electrics Accessories Drive Train Exhaust System Body Spark/Glow Ignition Engine Windows/Window Cleaning Lights Fuel Mixture Formation Interior Equipment ServiceProduct
Description
In stock
Price
(incl. VAT)
-
Thread Size: M12 x 1,
5 - Spanner Size: 19
- Number of pins: 2
- Colour Coding: blue
- Manufacturer: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Engine Code: 10 P
- Quantity: 2
- Number of pins: 2
- Height [mm]: 51.8
- Supplementary Article/Info 2: with seal ring
-
Thread Size: M12x1,
5 - Housing Colour: blue
- Spanner Size: 19
-
Supplementary Article/Supplementary Info: with gasket/
seal - Manufacturer: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Voltage [V]: 12
- Capacity at 12V: 70A
- Combi Switch Function: Normally Open Contact
- Colour: black
- Number of pins: 4
- Wiring Diagramme: S2
- Supplementary Article/Info 2: with resistor
- Protection Type (IP Code): IP54
- Inductive Load [A]: 35
- Capacitive Load [A]: 30
- Ohmic Load [A]: 40
- Plug Type ID: B
- Supplementary Article/Supplementary Info: without holder
- for OE number: 13171831
- Assy./disassy. by qualified personnel required!:
-
SVHC: 7439-
92- 1; Lead - Manufacturer: HELLA
- Name: HE 4RA933332531
Relay function: Pre-glow device, Heated windscreen, Heated rear window, Fan, heater/air conditioning, Comfort Equipment Variant (trim package), engine cooling, Clamp 15, ESP, Clamp 15R, Secondary Air System, Air Suspension, Engine control unit, Hydraulic Unit, Clamp 87, Starter, ABS, ABS recovery pump Brief Information: *** HELLA Electronics OE competence for over 60 years.
Laki Auto universal products
TecDoc catalogue for cars
TecDoc catalogue for trucks