Assembly categories
Filters Brake System Axle Steering Cooling / AC Electrics Towbar/Accessories Transmission Exhaust System Body Ignition Engine Windscreen Cleaning Lights Fuel Supply Interior ServiceProduct
Description
In stock
Price
(incl. VAT)
-
Oxygen Sensor: Oxygen Sensor,
Thread pre- greased -
Fabrication Number: ESL-
UV- 001 - Manufacturer: NTY
-
Name: NTY ESL-
UV- 001
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3'e tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
- Oxygen Sensor: Diagnostic Probe
-
Fabrication Number: ESL-
SK- 004 - Cable Length [mm]: 545
- Manufacturer: NTY
-
Oxygen Sensor: Diagnostic Probe,
Oxygen Sensor - Block Separation:
- Number of circuits: 4
- Connector/Clamp: Connector may need adjustment
- Name: LAMBDA ANDUR
- Manufacturer: MAX
Fitting Position: for cylinder 1-3, after catalytic converter, for cylinder 4-6
- Oxygen Sensor: Oxygen Sensor
- Guarantee: 3 years guarantee
- Weight [kg]: 0.12
- Always compare old and new part (in particular OE No.):
- Name: CE 09SKV121
- Manufacturer: ESEN SKV
- Oxygen Sensor: Oxygen Sensor
- Voltage [V]: 12
- Guarantee: 3 years guarantee
- Number of circuits: 4
- Weight [kg]: 0.14
- Operating Mode: Electric
- Always compare old and new part (in particular OE No.):
- Name: CE 09SKV904
- Manufacturer: ESEN SKV
- Oxygen Sensor: Diagnostic Probe
- Block Separation:
- Number of circuits: 4
-
Recommended change interval [km]: 160,
000 - Connector/Clamp: Connector may need adjustment
- Manufacturer: ENERGY
Fitting Position: after catalytic converter, for cylinder 1-3, for cylinder 4-6
- Quality: OE
- Manufacturer Restriction: DENSO
- Thread Size: M18x1.5
- Cable Length [mm]: 750
- Number of pins: 4
- Weight [g]: 103
- Gross Weight [g]: 152
- Manufacturer: DENSO
-
Name: DN DOX-
0119 - Quality class: Q
Oxygen Sensor: Diagnostic Probe, Heated, Finger probe, Oxygen Sensor
Additional information: "Tootja: DENSO
ESCORT VII SEDAN (GA
(kvaliteediklass: Q)"
Lisainfo: "Tootja: DENSO
ESCORT VII SEDAN (GA
(kvaliteediklass: Q)"
-
Fitting Position: for cylinder 1-
3, after catalytic converter -
Oxygen Sensor: Diagnostic Probe,
Finger probe, Heated - Cable Length [mm]: 970
- Name: LAMBDA ANDUR
- Manufacturer: DLP
-
Length [mm]: 1,
000 - Resistor [Ohm]: 4.5
- Number of circuits: 4
- Conductor Number: 4
-
Cable Length [mm]: 1,
000 - Oxygen Sensor: Heated
- Manufacturer: MAGNETI MARELLI
- Name: MM OSM039
-
Cable Length [mm]: 1,
000 - Number of pins: 4
- Oxygen Sensor: Diagnostic Probe
- Voltage [V]: 12
- Manufacturer: AIC
General Information: Our products are usually delivered without installation instructions. Installation may only be carried out by trained specialist technicians. Products supplied by us are exclusively intended for proper and appropriate use. The warranty is void in the event of improper, contrary to the intended purpose or unsuitable application or use. For electronic items that leave fault memory entries, it is essential to submit fault memory logs in the event of a claim. This consequently concerns all electronic items that are detected, monitored and controlled by the engine control unit, such as sensors of all kinds (e.g. NOX sensors, ABS sensors), mass airflow sensors, airbag slip rings, headlamp levelling control units, throttle valves, lambda sensors or EGR modules. If you encounter difficulties during a repair (troubleshooting max. 1 hr.), please contact technical support at: Phone: 040 - 25 30 66 55 Email: service@aic-germany.de This often avoids extensive troubleshooting that is disproportionate to normal repair times. The following applies to complaints: The more complete the processes are submitted, the faster they can be processed. Complete documentation includes the warranty application (incl. KBA no., chassis no., first registration, engine code, mileage), first and second installation invoice, fault memory log, guided troubleshooting and, if applicable, pictures. Incomplete documentation may result in rejection of the claim.
-
Oxygen Sensor: Diagnostic Probe,
Unheated - Number of pins: 4
- Connector Shape: D Shape
- Socket colour: black
- Cable Length [mm]: 920
- for OE number: 06E906265K
- Manufacturer: MEAT&DORIA
- Oxygen Sensor: Oxygen Sensor
- Cable Length [mm]: 290
- Alternatively:
- Supplementary Article/Info 2: without plug
- Number of circuits: 4
- Alternative Repair Kit: 570111
- Manufacturer: ERA
- Oxygen Sensor: Diagnostic Probe
- Construction Year to: 09.2008
- Engine Code: BDX
- Voltage [V]: 12
- Length [mm]: 971
- Guarantee: 3 years guarantee
- Number of circuits: 4
- Weight [kg]: 0.13
- Operating Mode: Electric
- Always compare old and new part (in particular OE No.):
- Name: CE 09SKV061
- Manufacturer: ESEN SKV
- Oxygen Sensor: Diagnostic Probe
- Construction Year to: 09.2008
- Engine Code: BDX
- Voltage [V]: 12
- Length [mm]: 971
- Guarantee: 3 years guarantee
- Number of circuits: 4
- Weight [kg]: 0.13
- Operating Mode: Electric
- Always compare old and new part (in particular OE No.):
- Name: CE 09SKV060
- Manufacturer: ESEN SKV
- Construction Year to: 09.2008
- Oxygen Sensor: Diagnostic Probe
- Voltage [V]: 12
-
Length [mm]: 1,
000 - Guarantee: 3 years guarantee
- Number of circuits: 4
- Weight [kg]: 0.15
- Resistor [Ohm]: 6
- Operating Mode: Electric
- Always compare old and new part (in particular OE No.):
- Manufacturer: ESEN SKV
- Oxygen Sensor: Diagnostic Probe
- Block Separation:
- Number of circuits: 4
-
Recommended change interval [km]: 160,
000 - Connector/Clamp: Connector may need adjustment
- Name: LAMBDA ANDUR
- Manufacturer: BOS
Fitting Position: after catalytic converter, for cylinder 1-3, for cylinder 4-6
-
Oxygen Sensor: Diagnostic Probe,
Heated -
Fitting Position: for cylinder 4-
6, after catalytic converter - Required quantity: 1
- Cable Length [mm]: 945
- Number of pins: 4
- Assy./disassy. by qualified personnel required!:
- Name: Lambda andur
- Manufacturer: HEL
Brief Information: *** HELLA Electronics OE competence for over 60 years.
- Fitting Position: after catalytic converter
-
Line insulation design: with silicone-
coated woven- fibre insulation -
Oxygen Sensor: Planar probe,
Heated, Thread pre- greased - Supplementary Article/Info 2: without plug
- Cable Length [mm]: 210
- Number of circuits: 4
- Weight [kg]: 0.09
- Manufacturer: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
-
Fitting Position: for cylinder 1-
3, after catalytic converter - Required quantity: 1
- Oxygen Sensor: Diagnostic Probe
- Cable Length [mm]: 915
- Number of pins: 4
- Assy./disassy. by qualified personnel required!:
- Name: Lambda andur
- Manufacturer: HEL
Brief Information: *** HELLA Electronics OE competence for over 60 years.
-
for OE number: 06E906265D,
06E906262J - Quality: OE
- Manufacturer Restriction: DENSO
- Thread Size: M18x1.5
-
Cable Length [mm]: 1,
260 - Number of pins: 4
- Weight [g]: 141
- Gross Weight [g]: 171
- Manufacturer: DENSO
-
Name: DN DOX-
1700
Oxygen Sensor: Diagnostic Probe, Heated, Finger probe, Oxygen Sensor
- Required quantity: 1
- Number of pins: 4
-
Cable Length [mm]: 1,
020 -
Thread Size: M18x1,
5 - Switch Pressure [bar]: 4
- Connector Shape: oval
- Manufacturer: VALEO
- Name: VA 368250
Oxygen Sensor: Diagnostic Probe, Planar probe, Thread pre-greased, Heated Fitting Position: before catalytic converter, after catalytic converter
- Oxygen Sensor: Diagnostic Probe
- Fitting Position: after catalytic converter
- for OE number: 06A 906 262 DM
-
Length [mm]: 1,
000 -
Thread Size: M18x1,
5 - Number of pins: 4
- Connector Shape: oval
- Technical Information Number: Universal 77004
- Manufacturer: FAE
- Engine Code: BDX
-
Fitting Position: Rear,
after catalytic converter -
Line insulation design: with silicone-
coated woven- fibre insulation -
Thread Size: M18 x 1,
5 - Socket colour: brown
- for OE number: 06E 906 265 D
- Weight [kg]: 0.17
- Connector Shape: D Shape
-
Length [mm]: 1,
020 - Cable Length [mm]: 975
- Number of pins: 4
-
Oxygen Sensor: Diagnostic Probe,
Thread pre- greased - Number of circuits: 4
- Manufacturer: VEMO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
-
Fitting Position: Left,
Right, before catalytic converter -
Oxygen Sensor: Regulating Probe,
Broadband oxygen sensor - Required quantity: 2
- Cable Length [mm]: 545
- Number of pins: 6
- Supplementary Article/Info 2: with fastening material
- Assy./disassy. by qualified personnel required!:
- Name: Lambda andur
- Manufacturer: HEL
Brief Information: *** HELLA Electronics OE competence for over 60 years.
-
Oxygen Sensor: Regulating Probe,
Oxygen Sensor - Engine Code: BDX
- Construction Year to: 09.2008
- Voltage [V]: 12
- Colour: blue
- Guarantee: 3 years guarantee
- Number of circuits: 5
- Weight [kg]: 0.11
- Operating Mode: Electric
- Always compare old and new part (in particular OE No.):
- Name: CE 09SKV906
- Manufacturer: ESEN SKV
- Oxygen Sensor: Regulating Probe
- Transmission Type: Automatic Transmission
- Number of pins: 5
- Cable Length [mm]: 560
- Version: IAM
- Manufacturer: METZGER
-
Fitting Position: Exhaust Manifold,
after catalytic converter - Required quantity: 2
- Connector Shape: D Shape
- Conductor Number: 5
- Length [mm]: 570
- Cable Length [mm]: 460
- Number of pins: 6
- Weight [kg]: 0.108
-
Oxygen Sensor: Thread pre-
greased - Manufacturer: VEMO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
Laki Auto universal products
TecDoc catalogue for cars
TecDoc catalogue for trucks