• for OE number: 000 905 06 00
• Width [mm]: 33
• Height [mm]: 30
• Length [mm]: 58
• Guarantee: 3 years guarantee
• Number of pins: 2
• Manufacturer: AT AUTOTEILE GERMANY

General Information: Products and spare parts supplied by us are only intended for the designated use. Installation may only be carried out by trained specialist personnel. Our products are not always supplied with installation instructions. Improper installation or inappropriate use may lead to the exclusion of warranty.

• Engine Code: M 274.920
• for article number: 7.8776, 7.8875
• Manufacturer: FACET

• Engine Code: M 274.920
• for article number: 1.880.776, 1.880.875
• Name: ANDUR,JAHUTUSVEDELIKU TEMP.
• Manufacturer: EPS

• Supplementary Article/Supplementary Info: with gasket/seal
• Number of pins: 2
• Assy./disassy. by qualified personnel required!:
• Mounting Type: Clamped
• Manufacturer: HELLA

Brief Information: *** HELLA Electronics OE competence for over 60 years.

• Required quantity: 2
• Sensor Type: Hall Sensor
• Mounting Type: Screw Connection
• Shape: oval
• Number of pins: 3
• Fitting Depth [mm]: 14.8
• Supplementary Article/Info 2: with seal ring
• Manufacturer: NRF

• Guarantee: 3 years guarantee
• Weight [kg]: 0.02
• Always compare old and new part (in particular OE No.):
• Manufacturer: SKV GERMANY

• Manufacturer: VEMO GERMANY

General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

• Quantity: 2
• Number of pins: 3
• Name: DE SS12310-12B1
• Manufacturer: DELPHI

• Engine Code: M 274.920
• for special equipment code: 266K
• Required quantity: 1
• Vehicle configuration line / variant: STEP1
• Manufacturer: FACET

• Number of pins: 3
• Fabrication Number: ECM-ME-002
• Manufacturer: NTY

• Engine Code: M 274.920
• for special equipment code: 266K
• Required quantity: 1
• Vehicle configuration line / variant: STEP1
• Name: EP 1.957.135
• Manufacturer: EPS

• Fabrication Number: ECP-ME-009
• Number of pins: 3
• Manufacturer: NTY

• Engine Code: M 274.920
• for OE number: A0081538928
• Number of pins: 3
• Guarantee: 3 years guarantee
• Weight [kg]: 0.03
• Always compare old and new part (in particular OE No.):
• Manufacturer: SKV GERMANY

• Number of connectors: 2
• Weight [kg]: 0.047
• Manufacturer: FEBI

General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.

• Fabrication Number: ECM-ME-008
• Manufacturer: NTY

• Fabrication Number: ECM-ME-007
• Manufacturer: NTY

• Version: IAM
• Manufacturer: METZGER

• Connector Shape: oval
• Number of pins: 3
• Supplementary Article/Info 2: without cable, with seal ring
• Manufacturer: TOPRAN

General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.

• Number of pins: 3
• Pressure from [kPA]: 25
• Manufacturer: DLP

Name: CZUJNIK CI—N. POWIETRZA DB A, E, CITAN/ RENAULT ARKANA, CAPTUR, CLIO, GRAND SCENIC, KADJAR, KANGOO, MEGANE, SCENIC, TALISMAN 1,3-2,0 13-

• Number of pins: 3
• Guarantee: 3 years guarantee
• Weight [kg]: 0.03
• Always compare old and new part (in particular OE No.):
• Manufacturer: SKV GERMANY
• Name: CE 17SKV161

• Name: Andur,kompressorirohk
• Manufacturer: BOS

• Exhaust System: for two-part exhaust system
• Number of pins: 3
• Supplementary Article/Info 2: without connection line
• Connector Shape: oval
• Guarantee: 3 years guarantee
• Weight [kg]: 0.07
• Always compare old and new part (in particular OE No.):
• Manufacturer: SKV GERMANY

• Manufacturer: TOPRAN

General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.

• Number of pins: 3
• Supplementary Article/Info 2: without connection line
• Connector Shape: oval
• Guarantee: 3 years guarantee
• Weight [kg]: 0.05
• Suction pipe connector diameter [mm]: 8.8
• Always compare old and new part (in particular OE No.):
• Manufacturer: SKV GERMANY

• Name: ANDUR,NUKKVOLLIPOSITSIOON
• Manufacturer: BOS

• Exhaust System: for two-part exhaust system
• Manufacturer: NRF

• Number of connectors: 3
• Fabrication Number: ECS-ME-007
• Manufacturer: NTY

• Required quantity: 2
• Sensor Type: Inductive Sensor
• Number of pins: 3
• Connector Shape: oval
• Supplementary Article/Info 2: without cable
• Manufacturer: VALEO

• Number of pins: 3
• Opening pressure [kPa]: 64.5
• Manufacturer: DLP

Name: CZUJNIK CI—NIENIA SPALIN DB A220, E300, GLA220, SLK200 12-

• not for special equipment code: 924, F212
• Production date to: 31.10.2017
• Number of pins: 3
• Number of mounting bores: 1
• Manufacturer: METZGER

• for special equipment code: 920
• Thread Size: M 12
• Thread Pitch [mm]: 1.5
• Supplementary Article/Info 2: with seal ring
• Number of pins: 3
• Spanner Size: 27
• Socket colour: black
• Manufacturer: TOPRAN

General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.

• Observe technical data:
• Manufacturer Restriction: Mercedes-Benz, VAG
• Number of pins: 2
• Cable Length [mm]: 175
• Cable Cross Section [mm²]: 0.75
• Contact surface: Silver-plated
• Supplementary Article/Supplementary Info: with socket housing, with gaskets/seals
• Supplementary Article/Info 2: with pipe
• suited for engine type: Petrol Injection
• Temperature range from [°C]: -25
• Temperature range to [°C]: +140
• Cable insulation material: Silicone
• Plug housing design: Plug sleeve housing
• SVHC: No SVHC present!
• Name: Kaabli remondikomplekt, sissepritseklapp
• Manufacturer: HBE

• Required quantity: 2
• Sensor Type: Hall Sensor
• Number of pins: 3
• Supplementary Article/Info 2: with seal ring
• Assy./disassy. by qualified personnel required!:
• Manufacturer: HELLA

Brief Information: *** HELLA Electronics OE competence for over 60 years.

• Exhaust System: after catalytic converter
• Oxygen Sensor: Diagnostic Probe
• Voltage [V]: 12
• Fitting Position: after catalytic converter
• Cable Length [mm]: 490
• Number of pins: 4
• Guarantee: 3 years guarantee
• Weight [kg]: 0.12
• Operating Mode: Electric
• Always compare old and new part (in particular OE No.):
• Manufacturer: SKV GERMANY

• Supplementary Article/Info 2: High Pressure Side
• Fuel Mixture Formation: Direct Injection
• Name: ANDUR,KšTUSEROHK
• Manufacturer: BOS

• for special equipment code: 920
• Number of pins: 3
• Fitting Position: EGR Valve
• Manufacturer: METZGER

• Oxygen Sensor: Diagnostic Probe, Planar probe, Heated
• Fitting Position: after catalytic converter
• Quantity: 1
• Cable Length [mm]: 395
• Manufacturer: DELPHI
• Name: DE ES21202-12B1

• Number of connectors: 3
• Weight [kg]: 0.048
• Manufacturer: FEBI BILSTEIN

General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.

• Fitting Position: before catalytic converter
• Number of pins: 2
• Cable Length [mm]: 585
• Sensor Type: PTC
• Name: Andur, heitgaasitemperatuur
• Manufacturer: MEY

• Oxygen Sensor: Oxygen Sensor
• Guarantee: 3 years guarantee
• Weight [kg]: 0.18
• Always compare old and new part (in particular OE No.):
• Manufacturer: SKV GERMANY
• Name: CE 09SKV408

• Exhaust System: before catalytic converter
• Quantity: 1
• Cable Length [mm]: 555
• Number of pins: 2
• Name: DE TS30386-12B1
• Manufacturer: DELPHI

• Oxygen Sensor: Regulating Probe, Broadband oxygen sensor, Heated
• Fitting Position: before catalytic converter
• Quantity: 1
• Cable Length [mm]: 535
• Name: DE ES21238-12B1
• Manufacturer: DELPHI

• Exhaust System: before catalytic converter
• Quantity: 1
• Cable Length [mm]: 574
• Number of pins: 2
• Name: DE TS30385-12B1
• Manufacturer: DELPHI

• Oxygen Sensor: Regulating Probe, Heated
• Conductor Number: 5
• Length [mm]: 650
• Number of circuits: 5
• Resistor [Ohm]: 4.9
• Cable Length [mm]: 650
• Manufacturer: MAGNETI MARELLI

• Number of pins: 4
• Connector Shape: oval
• Socket colour: black
• Fuel Type: Petrol
• Supplementary Article/Info 2: High Pressure Side
• for OE number: 2781530728
• Manufacturer: MEAT&DORIA

• Oxygen Sensor: Diagnostic Probe
• Fitting Position: after catalytic converter
• Name: Lambda andur
• Manufacturer: BOS

• Engine Code: M 274.920
• Sensor Type: Exhaust gas back pressure sensor
• Output Voltage, up to [V]: 5
• Measuring Range from [kPa]: 50
• Measuring Range to [kPa]: 350
• Number of pins: 3
• Supplementary Article/Supplementary Info: without accessories
• Manufacturer: PIERBURG

• Engine Code: M 274.920
• Fitting Position: before catalytic converter
• Fuel Mixture Formation: Direct injection with gasoline direct injection
• Operating Mode: Electric
• Voltage [V]: 5
• Conductor Number: 2
• Cable Length [mm]: 570
• Thread Size: M14 x 1,5
• Name: Andur, heitgaasitemperatuur
• Manufacturer: PIE

Manufacturer: BOSCH

• Oxygen Sensor: Oxygen Sensor
• Voltage [V]: 12
• Colour: red
• Guarantee: 3 years guarantee
• Number of circuits: 5
• Weight [kg]: 0.15
• Operating Mode: Electric
• Always compare old and new part (in particular OE No.):
• Manufacturer: SKV GERMANY
• Name: CE 09SKV905

• Oxygen Sensor: Regulating Probe, Heated
• External Thread Size: M18 x 1,5
• Spanner Size: 22
• Number of circuits: 6
• Cable Length [mm]: 805
• Weight [kg]: 0.121
• Manufacturer: FEBI BILSTEIN

General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.

• Oxygen Sensor: Regulating Probe
• Fitting Position: before catalytic converter
• Number of circuits: 5
• Overall Length [mm]: 630
• Manufacturer: BOSCH

• Oxygen Sensor: Oxygen Sensor
• Guarantee: 3 years guarantee
• Weight [kg]: 0.15
• Always compare old and new part (in particular OE No.):
• Technical Information: Universal
• Manufacturer: SKV GERMANY
• Name: CE 09SKV915

• Fitting Position: before catalytic converter
• for special equipment code: 920
• Number of pins: 2
• Connector Shape: oval
• Manufacturer: METZGER

• Fitting Position: Front, after SCR catalytic converter
• for special equipment code: 920
• Name: DRM 02313
• Manufacturer: DR.MOTOR AUTOMOTIVE

• Number of pins: 5
• Supplementary Article/Info 2: with cable
• Thread Size: M 20
• Thread Pitch [mm]: 1.5
• Cable Length [mm]: 595
• Spanner Size: 22
• Supplementary Article/Supplementary Info: with control unit
• Manufacturer: TOPRAN

General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.

• Cable Length [mm]: 590
• Thread Size: M20X1,5
• Number of pins: 5
• for OE number: A 000 905 62 04
• Supplementary Article/Info 2: Control Unit/Software must be trained/updated
• Assy./disassy. by qualified personnel required!:
• Manufacturer: HELLA ELEKTRYKA

Brief Information: *** HELLA Electronics OE competence for over 60 years.

• Fitting Position: after catalytic converter
• Engine Code: M 274.920
• Cable Length [mm]: 590
• Number of pins: 5
• Thread Size: M20
• Connector Shape: oval
• Name: DE ANS1028-12B1
• Manufacturer: DELPHI