• Number of pins: 2
• Housing Colour: light blue
• Connector Shape: oval
• Manufacturer: JP GROUP
• Lisainfo: Sender Unit, coolant temperature
• Additional information: Sender Unit, coolant temperature

Fabrication Number: ECT-CH-006

• Sensor Type: NTC Sensor
• Mounting Type: Bolted
• Connector Shape: oval
• Number of pins: 2
• Spanner Size: 19
• Thread Size: M12x1.5
• for OE number: 46462179
• Supplementary Article/Info 2: with seal ring
• Name: Andur,Jahutusvedeliku temp.
• Manufacturer: NRF

• Thread Size: M12x1.5
• Name: ANDUR,JAHUTUSVEDELIKU TEMP.
• Manufacturer: VER

• Connector Shape: oval
• Material: Plastic
• Number of pins: 2
• Plug Type: Female
• Sensor Type: NTC Sensor
• Spanner Size: S19
• Thread Size: M12*1,5
• Name: NI 207019
• Manufacturer: NISSENS

Technical Information: FIRST FIT - a time-saving installation! Find all additional parts such as O-rings, clip, washer in the box.

• Thread Size: M12x1.5
• Spanner Size: 19
• Corresponds to the original part in colour: green, black, grey, white
• Manufacturer: FAST

• Engine Code: Z 32 SEE
• Housing Colour: blue
• Number of pins: 2
• Thread Size: M12X1.5-6g
• Spanner Size: 19
• Name: ANDUR,JAHUTUSVEDELIKU TEMP.
• Manufacturer: DLP

• Outer Diameter [mm]: 7.4
• Resistor [Ohm]: 2,080, 294
• Supplementary Article/Supplementary Info: with seal
• External Thread [mm]: 12
• Thread Pitch [mm]: 1.5
• Temperature range [°C]: 25, 80
• Mounting Type: Bolted
• Colour: blue
• Spanner Size: 19
• Sensor Type: NTC Sensor
• Number of pins: 2
• Corresponds to the original part in colour: black, white, light blue
• not for trim level: 4mm
• Assy./disassy. by qualified personnel required!:
• Name: ANDUR,JAHUTUSVEDELIKU TEMP.
• Manufacturer: HEL

Brief Information: *** HELLA Electronics OE competence for over 60 years.

• Number of pins: 2
• Thread Size: M12x1,5
• Supplementary Article/Info 2: with seal ring
• Housing Colour: black
• Weight [kg]: 0.032
• Manufacturer: VEMO GERMANY

General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

• Thread Size: M12 x 1,5
• Number of pins: 2
• Manufacturer: ERA

• Engine Code: Z 32 SEE
• Thread Size: M12x1,5
• Spanner Size: 19
• Corresponds to the original part in colour: white, green, black
• for article number: 1.880.170, 1.880.190
• Name: ANDUR,JAHUTUSVEDELIKU TEMP.
• Manufacturer: EPS

• Engine Code: Z 32 SEE
• Sensor Type: NTC Sensor
• Thread Size: M12 x 1,5
• Spanner Size: 19
• Supplementary Article/Info 2: with seal ring
• Colour: grey
• Number of pins: 2
• Name: ANDUR,JAHUTUSVEDELIKU TEMP.
• Manufacturer: MEY

• Fabrication Number: ECP-PL-030
• Manufacturer: NTY

• Number of pins: 2
• Weight [kg]: 0.3
• Packaging length [cm]: 12
• Packaging width [cm]: 8
• Packaging height [cm]: 6

• Number of pins: 3
• Fabrication Number: ECC-PL-004

Manufacturer: BOSCH

Manufacturer: MAGNETI MARELLI

• Vehicle Identification Number (VIN) from: AB000001
• Number of pins: 3
• Name: DE SS11312
• Manufacturer: DELPHI

Manufacturer: BOSCH

• Required quantity: 1
• Voltage [V]: 12
• Number of pins: 3
• Sensor Type: Hall Sensor
• Supplementary Article/Info 2: without cable
• Housing Colour: black
• Manufacturer: BREMI

• Vehicle Identification Number (VIN) to: 80999999/93999999, 9B999999
• Number of pins: 3
• Manufacturer: DELPHI
• Name: DE SS11090

• Number of circuits: 4
• Lambda Sensor: Regulating Probe
• Manufacturer: KAMOKA

• Lambda Sensor: Diagnostic Probe, Thread pre-greased
• Fabrication Number: ESL-SK-000
• Manufacturer: NTY
• Name: NTY ESL-SK-000

• Number of pins: 2
• Name: DE AS10192
• Manufacturer: DELPHI

• Name: ANDUR,NUKKVOLLIPOSITSIOON
• Manufacturer: BOS

• Vehicle Identification Number (VIN) to: 80999999, 9B999999, 93999999
• Manufacturer: BOSCH

• Construction Year from: 03.2007
• Vehicle Identification Number (VIN) to: 80999999/93999999, 9B999999
• Block Separation:
• Fitting Position: Front, after catalytic converter
• Lambda Sensor: Diagnostic Probe, Planar probe, Heated
• Spanner Size: 22
• Name: Lambda andur
• Manufacturer: MAX

• Lambda Sensor: Lambda Sensor
• Voltage [V]: 12
• Number of circuits: 4
• Weight [kg]: 0.09
• Resistor [Ohm]: 9
• Operating Mode: Electric
• Warranty: 3 years warranty
• Manufacturer: SKV GERMANY
• Name: CE 09SKV909

• Lambda Sensor: Diagnostic Probe, Finger probe
• Fitting Position: after catalytic converter
• Number of circuits: 4
• Connector/Clamp: Connector may need adjustment
• Transmission Type: Manual Transmission
• Name: LAMBDA ANDUR
• Manufacturer: MAX

• Number of pins: 3
• Weight [kg]: 0.024
• Manufacturer: VEMO GERMANY

General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

• Lambda Sensor: Diagnostic Probe
• Exhaust System: after catalytic converter
• Fitting Position: Front
• Length [mm]: 400
• Number of connectors: 4
• Manufacturer: VERNET

• Vehicle Identification Number (VIN) to: 80999999, *********9B999999, 93999999
• Lambda Sensor: Diagnostic Probe, Heated
• External Thread Size: M18 x 1,5
• Spanner Size: 22
• Number of circuits: 4
• Cable Length [mm]: 450
• Weight [kg]: 0.087
• Manufacturer: FEBI

General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.

• Number of pins: 3
• Fitting Depth [mm]: 38
• Manufacturer: ERA

• Engine Code: Z 32 SEE
• Lambda Sensor: Diagnostic Probe, Unheated
• Required quantity: 2
• Number of pins: 4
• Cable Length [mm]: 520
• Quality: OE EQUIVALENT
• Manufacturer: MEAT&DORIA

• Vehicle Identification Number (VIN) to: 80999999, *********9B999999, 93999999
• Lambda Sensor: Diagnostic Probe, Heated
• External Thread Size: M18 x 1,5
• Spanner Size: 22
• Number of circuits: 4
• Cable Length [mm]: 450
• Weight [kg]: 0.087
• Name: SW 33 10 3204
• Manufacturer: SWAG

General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.

• Lambda Sensor: Lambda Sensor
• Cable Length [mm]: 290
• Alternatively:
• Number of circuits: 4
• Alternative Repair Kit: 570112
• Manufacturer: ERA

• Engine Code: Z32SEE
• Lambda Sensor: Diagnostic Probe, Thread pre-greased
• Fitting Position: after catalytic converter
• Required quantity: 2
• Line insulation design: with silicone-coated woven-fibre insulation
• Overall Length [mm]: 448
• Weight [kg]: 0.11
• Manufacturer: VEMO GERMANY

General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

• Fitting Position: after catalytic converter
• Vehicle Identification Number (VIN) to: 80999999/93999999, 9B999999
• Block Separation:
• Lambda Sensor: Diagnostic Probe, Planar probe, Heated
• Cable Length [mm]: 400
• Name: LAMBDA ANDUR
• Manufacturer: DLP

• Lambda Sensor: Diagnostic Probe
• Fitting Position: after catalytic converter
• Number of circuits: 4
• Recommended change interval [km]: 160,000
• Connector/Clamp: Connector may need adjustment
• Name: LAMBDA ANDUR
• Manufacturer: BOS

• Lambda Sensor: Diagnostic Probe
• Fitting Position: after catalytic converter
• Cable Length [mm]: 350
• Number of pins: 4
• Assy./disassy. by qualified personnel required!:
• Name: Lambda andur
• Manufacturer: HEL

Brief Information: *** HELLA Electronics OE competence for over 60 years.

• Lambda Sensor: Diagnostic Probe
• Fitting Position: after catalytic converter
• Length [mm]: 350
• Technical Information Number: Universal 77015
• Manufacturer: FAE

• Lambda Sensor: Lambda Sensor
• Voltage [V]: 12
• Colour: red
• Number of circuits: 5
• Weight [kg]: 0.15
• Operating Mode: Electric
• Warranty: 3 years warranty
• Manufacturer: SKV GERMANY
• Name: CE 09SKV905

• Engine Code: Z 32 SEE
• Fitting Position: before catalytic converter
• Cable Length [mm]: 500
• Conductor Number: 5
• Number of circuits: 5
• Name: EP 1.998.404
• Manufacturer: EPS

Lambda Sensor: Regulating Probe, Heated, Planar probe, Broadband lambda sensor, Thread pre-greased

• Fitting Position: Exhaust Manifold
• Lambda Sensor: Broadband lambda sensor, Regulating Probe
• Number of pins: 5
• Connector Shape: D Shape
• Cable Length [mm]: 440
• for article number: 81603E
• Quality: OE EQUIVALENT
• Name: Lambda andur
• Manufacturer: MD

• Lambda Sensor: Lambda Sensor
• Weight [kg]: 0.15
• Warranty: 3 years warranty
• Technical Information: Universal
• Name: CE 09SKV915
• Manufacturer: ESEN SKV

• Recommended additional repairs: Air Filter
• Name: OHUMASSIMOOTJA
• Manufacturer: BOS

• Construction Year from: 10.2006
• Construction Year to: 12.2010
• Engine Code: Z32SE
• Fitting Position: before catalytic converter
• Number of pins: 6
• Cable Length [mm]: 500
• Thread Size: M18x1,5
• Switch Pressure [bar]: 4
• Weight [kg]: 0.15
• Manufacturer: VALEO
• Name: VA 368417

Lambda Sensor: Planar probe, Broadband lambda sensor, Thread pre-greased, Heated