Assembly categories
Filters Brake System Axle Steering Cooling / AC Electrics Towbar/Accessories Transmission Exhaust System Body Ignition Engine Windscreen Cleaning Lights Fuel Supply Interior ServiceProduct
Description
In stock
Price
(incl. VAT)
- Fitting Position: Front Axle both sides
- Inner Diameter [mm]: 97.8
- Width [mm]: 8.65
- Outer Diameter [mm]: 110
- Number of Teeth, ABS ring: 54
- Manufacturer: TRISCAN
-
Lisainfo: CITROEN,
FIAT, PEUGEOT -
Additional information: CITROEN,
FIAT, PEUGEOT
- Fitting Position: Front Axle both sides
- Width [mm]: 8.1
- Number of Teeth, ABS ring: 54
- Inner Diameter [mm]: 99.9
- Outer Diameter [mm]: 110
- Weight [kg]: 0.073
- Manufacturer: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Fitting Position: Front Axle both sides
- Inner Diameter [mm]: 97.8
- Thickness [mm]: 8.65
- Number of Teeth: 54
- Manufacturer: AIC
General Information: Our products are usually delivered without installation instructions. Installation may only be carried out by trained specialist technicians. Products supplied by us are exclusively intended for proper and appropriate use. The warranty is void in the event of improper, contrary to the intended purpose or unsuitable application or use. For electronic items that leave fault memory entries, it is essential to submit fault memory logs in the event of a claim. This consequently concerns all electronic items that are detected, monitored and controlled by the engine control unit, such as sensors of all kinds (e.g. NOX sensors, ABS sensors), mass airflow sensors, airbag slip rings, headlamp levelling control units, throttle valves, lambda sensors or EGR modules. If you encounter difficulties during a repair (troubleshooting max. 1 hr.), please contact technical support at: Phone: 040 - 25 30 66 55 Email: service@aic-germany.de This often avoids extensive troubleshooting that is disproportionate to normal repair times. The following applies to complaints: The more complete the processes are submitted, the faster they can be processed. Complete documentation includes the warranty application (incl. KBA no., chassis no., first registration, engine code, mileage), first and second installation invoice, fault memory log, guided troubleshooting and, if applicable, pictures. Incomplete documentation may result in rejection of the claim.
- Fitting Position: Front Axle
- Inner Diameter [mm]: 112
- Width [mm]: 8.2
- Outer Diameter [mm]: 122
- Number of Teeth, ABS ring: 54
- Manufacturer: TRISCAN
-
Lisainfo: FIAT,
PSA -
Additional information: FIAT,
PSA
- Fitting Position: Front Axle both sides
- Transmission Type: Manual Transmission
-
Payload [kg]: 1,
800 - Inner Diameter [mm]: 113.2
- Width [mm]: 8
- Outer Diameter [mm]: 121
- Number of Teeth, ABS ring: 54
- Manufacturer: TRISCAN
-
Lisainfo: CITROEN,
FIAT, PEUGEOT -
Additional information: CITROEN,
FIAT, PEUGEOT
-
Fitting Position: Front Axle Left,
Front Axle Right -
Cable Length [mm]: 1,
400 - Number of pins: 2
- Fitting Depth [mm]: 28
- Guarantee: 3 years guarantee
- Weight [kg]: 0.18
- Always compare old and new part (in particular OE No.):
- Manufacturer: SKV GERMANY
- Name: CE 06SKV431
- Fitting Position: Rear Axle Left
- Sensor Type: Passive sensor
-
Length [mm]: 1,
450 - Socket colour: white
- Manufacturer: JP GROUP
- Fitting Position: Rear Axle Right
- Sensor Type: Passive sensor
-
Length [mm]: 2,
230 - Socket colour: white
-
Manufacturer: JP GROUP A/
S
- Fitting Position: Front Axle both sides
-
Cable Length [mm]: 1,
355 - Number of connectors: 2
- Manufacturer: JPN
- Number of pins: 2
- Connector Shape: round
-
Cable Length [mm]: 1,
400 - Sensor Type: Inductive Sensor
- Fitting Depth [mm]: 28
-
Fitting Position: Front Axle Right,
Front Axle Left - for OE number: 454590
- Manufacturer: MEAT&DORIA
- Transmission Type: Manual Transmission
-
Payload [kg]: 1,
000, 1, 400 -
Fitting Position: Front Axle Left,
Front Axle Right - Number of Teeth: 54
- Outer Diameter [mm]: 110
- Inner Diameter [mm]: 98
- Width [mm]: 8.7
- Manufacturer: METZGER
- Brake System: Bosch
-
Cable Length [mm]: 1,
425 - Sensor Type: Inductive Sensor
- Number of pins: 2
- Fitting Position: Front Axle
- Manufacturer: FAE
-
Fitting Position: Front Axle Right,
Front Axle Left, Front Axle -
Length [mm]: 1,
400 - Braking/Drive Dynamics: for vehicles with ABS
- Rated Voltage [V]: 12
- Required quantity: 2
-
Resistor [Ohm]: 1,
650 -
Cable Length [mm]: 1,
355 -
Sensor Type: Inductive Sensor,
Passive sensor - Number of pins: 2
- Fitting Depth [mm]: 28
- Supplementary Article/Info 2: with cable
- Weight [kg]: 0.132
- Manufacturer: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Fitting Position: Front Axle
-
Overall Length [mm]: 1,
450 - Length [mm]: 28
- Sensor Type: Passive sensor
- Socket colour: white
-
Cable Length [mm]: 1,
355 - paired article number: 30658
- Weight [kg]: 0.2
- Manufacturer: A.B.S.
- Fitting Position: Front Axle
- Sensor Type: Passive sensor
- Number of occupied pins: 2
-
Cable Length [mm]: 1,
409 - Manufacturer: DELPHI LOCKHEED HAMULCE
- Name: DE SS20258
- Quality class: PJ
- Required quantity: 2
- Fitting Position: Front Axle
- Supplementary Article/Info 2: with cable
- Manufacturer: BREMI
- Number of connectors: 2
-
Resistor [Ohm]: 1,
650 -
Fitting Position: Front Axle Left,
Front Axle Right -
Cable Length [mm]: 1,
355 - Weight [kg]: 0.134
- Manufacturer: FEBI
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
-
Fitting Position: Right,
Left, Front Axle -
Cable Length [mm]: 1,
425 -
Manufacturer: SNR /
NTN- SNR/ - Name: SN ASB159.31
- Fitting Position: Rear Axle Left
-
Cable Length [mm]: 1,
450 - Sensor Type: Inductive Sensor
- Number of pins: 2
- Manufacturer: FAE
-
Length [mm]: 1,
450 - Sensor Type: Passive sensor
- paired article number: FT80500
- Fitting Position: Rear Axle Left
- Manufacturer: FAST
- Fitting Position: Front Axle
-
Cable Length [mm]: 1,
360 - Sensor Type: Passive sensor
- Manufacturer: OPTIMAL ZAWIESZENIE
- Required quantity: 1
- Fitting Position: Rear Axle Left
- Supplementary Article/Info 2: with cable
- Sensor Type: Inductive Sensor
- Number of pins: 2
- Manufacturer: BREMI
-
Length [mm]: 2,
230 - Sensor Type: Passive sensor
- Fitting Position: Rear Axle Right
- Manufacturer: FAST
- Fitting Position: Front Axle
- Sensor Type: Inductive Sensor
- Number of pins: 2
- Manufacturer: METZGER
- Fitting Position: Rear Axle Left
-
Overall Length [mm]: 1,
570 - Length [mm]: 53
- Sensor Type: Passive sensor
- Socket colour: white
-
Cable Length [mm]: 1,
450 - paired article number: 30660
- Weight [kg]: 0.21
- Manufacturer: A.B.S.
- Fitting Position: Rear Axle Right
-
Overall Length [mm]: 2,
230 - Length [mm]: 53
- Sensor Type: Passive sensor
- Socket colour: white
-
Cable Length [mm]: 2,
110 - paired article number: 30659
- Weight [kg]: 0.25
- Manufacturer: A.B.S.
Laki Auto universal products
TecDoc catalogue for cars
TecDoc catalogue for trucks