• for OE number: MHK101086
• Quality: OE
• Manufacturer Restriction: DENSO
• Thread Size: M18x1.5
• Cable Length [mm]: 770
• Number of pins: 4
• Weight [g]: 116
• Supplementary Article/Info 2: with rubber grommet
• Gross Weight [g]: 149
• Manufacturer: DENSO

Oxygen Sensor: Diagnostic Probe, Heated, Planar probe, Thread pre-greased, Oxygen Sensor Additional information: "Tootja: DENSO
25 (RF), 09.99-05.05
(kvaliteediklass: Q)" Lisainfo: "Tootja: DENSO
25 (RF), 09.99-05.05
(kvaliteediklass: Q)"

• Exhaust System: for pre-catalytic converter
• for OE number: MHK100840
• Quality: OE
• Manufacturer Restriction: DENSO
• Thread Size: M18x1.5
• Cable Length [mm]: 620
• Number of pins: 4
• Weight [g]: 105
• Gross Weight [g]: 138
• Manufacturer: DENSO
• Name: DN DOX-2017

Oxygen Sensor: Regulating Probe, Heated, Planar probe, Thread pre-greased, Oxygen Sensor Additional information: "Tootja: DENSO
FREELANDER (LN), 02.
(kvaliteediklass: Q)" Lisainfo: "Tootja: DENSO
FREELANDER (LN), 02.
(kvaliteediklass: Q)"

• Engine Code: 14 K4M
• Housing Colour: white
• Thread Size: M12x1,5
• Spanner Size: 22
• Manufacturer: FACET

• Engine Code: 14 K4M
• Housing Colour: white
• Thread Size: M12x1,5
• Spanner Size: 22
• Name: ANDUR,JAHUTUSVEDELIKU TEMP.
• Manufacturer: EPS

• Engine Code: 14 K4M
• Housing Colour: brown
• Thread Size: M12x1,5
• Spanner Size: 19
• Manufacturer: FACET

• Engine Code: 14 K4M
• Housing Colour: brown
• Thread Size: M12x1,5
• Spanner Size: 19
• Name: ANDUR,JAHUTUSVEDELIKU TEMP.
• Manufacturer: EPS

• Number of pins: 2
• for OE number: MEK100060
• Weight [kg]: 0.033
• Manufacturer: VEMO GERMANY

General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

• Housing Colour: brown
• Number of pins: 2
• Thread Size: M 12x1,5
• Manufacturer: FAE

• Number of pins: 2
• Manufacturer: DELPHI
• Name: DE SS11174

• Oxygen Sensor: Diagnostic Probe, Thread pre-greased
• Fabrication Number: ESL-SK-000
• Manufacturer: NTY
• Name: NTY ESL-SK-000

• Number of pins: 2
• Thread Size: M10x1,25
• Power [W]: 0.06
• Manufacturer: METZGER

• Oxygen Sensor: Regulating Probe
• Number of circuits: 4
• Manufacturer: KAMOKA

• Required quantity: 1
• Name: CZUJNIK CI—N. POWIETRZA MINI COOPER S 02-
• Manufacturer: BRM

• Number of pins: 4
• Pressure from [kPA]: 15
• Name: ANDUR,OHUVOTU ROHK
• Manufacturer: DLP

• Alternatively:
• Number of pins: 4
• Alternative Repair Kit: 551396
• Manufacturer: ERA

• Measuring Range from [kPa]: 10
• Measuring Range to [kPa]: 118
• Measuring Range from [V]: 0.31
• Measuring Range to [V]: 4.75
• Number of connectors: 4
• Manufacturer: VERNET

• Engine Code: 14 K4M
• Number of pins: 3
• Fitting Depth [mm]: 27.5
• Manufacturer: ERA

• Engine Code: 14 K4M
• Pressure from [kPA]: 10
• Pressure to [kPA]: 118
• Output Voltage, from [V]: 0.31
• Output Voltage, up to [V]: 4.75
• Name: ANDUR,OHUVOTU ROHK
• Manufacturer: EPS

• Oxygen Sensor: Oxygen Sensor
• Length [mm]: 972
• Number of circuits: 4
• Manufacturer: FAST

• Oxygen Sensor: Regulating Probe, Planar probe, Heated
• Fitting Position: before catalytic converter
• Vehicle Identification Number (VIN) to: 471564
• Cable Length [mm]: 605
• Name: LAMBDA ANDUR
• Manufacturer: DLP

Manufacturer: MAGNETI MARELLI

• Resistor [Ohm]: 9
• Length [mm]: 568
• Conductor Number: 4
• Number of circuits: 4
• Cable Length [mm]: 568
• Oxygen Sensor: Heated
• Name: LAMBDA ANDUR
• Manufacturer: MAG

• Oxygen Sensor: Oxygen Sensor
• Voltage [V]: 12
• Length [mm]: 605
• Guarantee: 3 years guarantee
• Number of circuits: 4
• Weight [kg]: 0.13
• Resistor [Ohm]: 6
• Operating Mode: Electric
• Always compare old and new part (in particular OE No.):
• Name: CE 09SKV578
• Manufacturer: ESEN SKV

• Oxygen Sensor: Regulating Probe, Oxygen Sensor
• Exhaust System: before catalytic converter
• Voltage [V]: 12
• Length [mm]: 568
• Guarantee: 3 years guarantee
• Number of circuits: 4
• Weight [kg]: 0.14
• Resistor [Ohm]: 9
• Operating Mode: Electric
• Always compare old and new part (in particular OE No.):
• Manufacturer: SKV GERMANY
• Name: CE 09SKV730

• Engine Code: 14K2
• Oxygen Sensor: Regulating Probe
• Fitting Position: before catalytic converter
• Vehicle Identification Number (VIN) to: 471564
• Number of circuits: 4
• Recommended change interval [km]: 160,000
• Connector/Clamp: Connector may need adjustment
• Name: LAMBDA ANDUR
• Manufacturer: BOS

• Engine Code: 14 K4M
• Line insulation design: with silicone-coated woven-fibre insulation
• Supplementary Article/Info 2: without plug
• Number of pins: 4
• for OE number: V99760001
• Cable Length [mm]: 210
• Number of circuits: 4
• Weight [kg]: 0.09
• Length [mm]: 350
• Fitting Position: after catalytic converter
• Manufacturer: VEMO GERMANY

Oxygen Sensor: Regulating Probe, Finger probe, Heated, Thread pre-greased General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

• Oxygen Sensor: Regulating Probe, Planar probe, Heated
• Fitting Position: before catalytic converter
• Vehicle Identification Number (VIN) from: 471565
• Cable Length [mm]: 540
• Name: LAMBDA ANDUR
• Manufacturer: DLP

• Engine Code: 14K2
• Oxygen Sensor: Diagnostic Probe, Regulating Probe
• Vehicle Identification Number (VIN) from: 471565
• Block Separation:
• Number of circuits: 4
• Recommended change interval [km]: 160,000
• Connector/Clamp: Connector may need adjustment
• Name: LAMBDA ANDUR
• Manufacturer: BOS

Fitting Position: after catalytic converter, before catalytic converter

• Exhaust System: for pre-catalytic converter
• Quality: OE
• Manufacturer Restriction: DENSO
• Thread Size: M18x1.5
• Cable Length [mm]: 750
• Number of pins: 4
• Weight [g]: 93
• Gross Weight [g]: 140
• Manufacturer: DENSO
• Name: DN DOX-0150
• Quality class: Q

Oxygen Sensor: Regulating Probe, Heated, Planar probe, Thread pre-greased, Oxygen Sensor Additional information: "Tootja: DENSO
(kvaliteediklass: Q)" Lisainfo: "Tootja: DENSO
(kvaliteediklass: Q)"

• Engine Code: 14K2
• Oxygen Sensor: Regulating Probe
• Fitting Position: before catalytic converter
• Vehicle Identification Number (VIN) to: 471564
• Number of circuits: 4
• Overall Length [mm]: 623
• Available as universal article as well, see article no.: 0258986506
• Recommended change interval [km]: 100,000
• Name: LAMBDA ANDUR
• Manufacturer: BOS

• Transmission Type: Manual Transmission
• Engine Code: 14 K4F4
• Oxygen Sensor: Regulating Probe
• Fitting Position: before catalytic converter
• Length [mm]: 620
• Number of circuits: 4
• Manufacturer: VDO

• Engine Code: 14K2
• Oxygen Sensor: Diagnostic Probe
• Fitting Position: after catalytic converter
• Vehicle Identification Number (VIN) from: 471565
• Number of circuits: 4
• Overall Length [mm]: 773
• Available as universal article as well, see article no.: 0258986615
• Recommended change interval [km]: 160,000
• Manufacturer: BOSCH

• Engine Code: 14K2
• Oxygen Sensor: Regulating Probe
• Fitting Position: before catalytic converter
• Vehicle Identification Number (VIN) from: 471565
• Number of circuits: 4
• Overall Length [mm]: 568
• Available as universal article as well, see article no.: 0258986615
• Recommended change interval [km]: 160,000
• Manufacturer: BOSCH

• Sensor Type: Hall Sensor
• Mounting Type: Screw Connection
• Shape: oval
• Number of pins: 3
• Supplementary Article/Info 2: with seal ring