Tootekategooriad
Filtrid Pidurid vedrustus/alusvanker Roolisüsteem Jahutus/kliima Elektrisüsteem Veokonks/lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütus Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
- Oxygen Sensor: Diagnostic Probe
- Fitting Position: after catalytic converter
- Cable Length [mm]: 970
- Guarantee: 3 years guarantee
- Weight [kg]: 0.15
- Conductor Number: 4
- Always compare old and new part (in particular OE No.):
- Tootja: SKV GERMANY
- Nimetus: CE 09SKV126
- Väljalaskesüsteem: pärast katalüsaatorit
- Oxygen Sensor: Finger probe
-
Thread Size: M18 x 1,
5 - Cable Length [mm]: 800
- Number of pins: 4
- Guarantee: 3 years guarantee
- Weight [kg]: 0.13
- Always compare old and new part (in particular OE No.):
- Tootja: SKV GERMANY
- Nimetus: CE 09SKV127
-
Oxygen Sensor: Diagnostic Probe,
Heated - Fitting Position: after catalytic converter
- Rated Voltage [V]: 12
- Number of pins: 4
- Connector Shape: D Shape
- Cable Length [mm]: 837
- Overall Length [mm]: 870
- Spanner Size: 22
- Thread Size: M 18
- Thread Pitch [mm]: 1.5
- Thread Length [mm]: 9
-
Supplementary Article/Info 2: with cable,
with heat shield pipe - Lubrication: with grease lubrication
- Tootja: TOPRAN
General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.
- Oxygen Sensor: Finger probe
- Fitting Position: Front
- General Information: lambda probe; front
- Tootja: VIKA
- Mootorikood: CPTA
- Installatsiooni pool: pärast katalüsaatorit
- vajaminev tükihulk: 1
- Lambda andur: Diagnoosisond
- Cable Length [mm]: 800
- Conductor Number: 4
-
Oxygen Sensor: Heated,
Planar probe, Thread pre- greased - Available as universal article as well, see article no.: 1.997.007
- Number of circuits: 4
- Nimetus: EP 1.998.199
- Tootja: EPS
- Oxygen Sensor: Diagnostic Probe
- Voltage [V]: 12
-
Length [mm]: 1,
000 - Guarantee: 3 years guarantee
- Number of circuits: 4
- Weight [kg]: 0.15
- Resistor [Ohm]: 6
- Operating Mode: Electric
- Always compare old and new part (in particular OE No.):
- Tootja: ESEN SKV
- Mootorikood: CPTA
- Installatsiooni pool: pärast katalüsaatorit
- vajaminev tükihulk: 1
- Lambda andur: Diagnoosisond
- Cable Length [mm]: 800
- Conductor Number: 4
-
Oxygen Sensor: Heated,
Planar probe, Thread pre- greased - Available as universal article as well, see article no.: 10.7007
- Number of circuits: 4
- Tootja: FACET
-
Oxygen Sensor: Diagnostic Probe,
Heated - Voltage [V]: 12
- Length [mm]: 595
- Guarantee: 3 years guarantee
- Number of circuits: 4
- Weight [kg]: 0.13
- Resistor [Ohm]: 6
- Operating Mode: Electric
- Always compare old and new part (in particular OE No.):
- Tootja: ESEN SKV
- Lambda andur: Diagnoosisond
- Installatsiooni pool: pärast katalüsaatorit
- Tootja: BOSCH
- Oxygen Sensor: Heated
- Conductor Number: 5
- General Information: lambda probe; 5 wire
- Tootja: VIKA
- Oxygen Sensor: Diagnostic Probe
- Number of pins: 4
- Cable Length [mm]: 970
- Quality: OE EQUIVALENT
- for OE number: 04E906262GC
- Tootja: MEAT&DORIA
- Lambda andur: Diagnoosisond
- Ehitusaasta kuni: 05.2013
- Mootorikood: CPTA
- Väljalaskesüsteem: pärast katalüsaatorit
- Voltage [V]: 12
- Guarantee: 3 years guarantee
- Weight [kg]: 0.1
- Operating Mode: Electric
- Always compare old and new part (in particular OE No.):
- Nimetus: CE 09SKV991
- Tootja: ESEN SKV
- Mootorikood: CPTA
- Ehitusaasta alates: 05.2013
-
Line insulation design: with silicone-
coated woven- fibre insulation - Connector Shape: D Shape
- Socket colour: black
- for OE number: 04E 906 262 K
- Weight [kg]: 0.117
- Length [mm]: 720
- Number of pins: 4
-
Oxygen Sensor: Finger probe,
Diagnostic Probe, Thread pre- greased - Number of circuits: 4
- Exhaust System: after catalytic converter
- Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Lambda andur: Sond
- Number of pins: 5
- Cable Length [mm]: 560
- Version: IAM
- Tootja: METZGER
- Mootorikood: CPTA
- Installatsiooni pool: Väljalaskekollektor
- Connector Shape: D Shape
- Conductor Number: 5
- Length [mm]: 570
- Cable Length [mm]: 460
- Number of pins: 6
- Exhaust System: after catalytic converter
- Weight [kg]: 0.108
-
Oxygen Sensor: Thread pre-
greased - Tootja: VEMO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.