Tooted

Toode

Kirjeldus

Laoseis

Hind

(km-ga)

786.230
Shaft Seal, camshaft
ELRING
  • Installatsiooni pool: stirnseitig
  • Inner Diameter [mm]: 26
  • Outer Diameter [mm]: 41
  • Height [mm]: 8
  • Radial Shaft Seal Design: AW
  • Swirl Type: Right-hand Twist
  • Tootja: ELRING

Material: PTFE (polytetrafluoroethylene)/ACM (polyacrylate rubber) General Information: Mounting dry and without any additional oil and grease

Tellitav 1 tp
4
6,82
Kaup on euroopa kesklaos. Tarne 1 tööpäev LakiAuto lattu. Tellimused hiljemalt 17.00
Lisainfo OE koodid Seotud sõidukid
49486581
Shaft Seal, crankshaft
CORTECO
  • Fitting Position: frontal sided
  • Height 1 [mm]: 50.5
  • Outer Diameter 1 [mm]: 221.4
  • Outer Diameter 2 [mm]: 136.3
  • Inner Diameter 1 [mm]: 35
  • Material: PTFE (polytetrafluoroethylene)
  • Tootja: CORTECO USZCZELNIACZE TRUCK
Tellitav 1p
50
16,30
Kaup on euroopa kesklaos. Tellimus tööpäeviti kell 17.00
Lisainfo OE koodid Seotud sõidukid
49486582
Shaft Seal, crankshaft
CORTECO
  • Fitting Position: transmission sided
  • Supplementary Article/Info 2: with mounting sleeve
  • Height 1 [mm]: 15.7
  • Outer Diameter 1 [mm]: 130.4
  • Outer Diameter 2 [mm]: 166.9
  • Inner Diameter 1 [mm]: 85
  • Material: PTFE (polytetrafluoroethylene)
  • Tootja: CORTECO USZCZELNIACZE TRUCK
Tellitav 1p
3
20,17
Kaup on euroopa kesklaos. Tellimus tööpäeviti kell 17.00
Lisainfo OE koodid Seotud sõidukid
V10-3682
Shaft Seal, crankshaft
VAICO
  • Mootorikood: DFBA
  • Inner Diameter [mm]: 35
  • Outer Diameter [mm]: 136.3
  • Fitting Position: frontal sided
  • Weight [kg]: 0.3
  • Tootja: VAICO

General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

Tellitav 1tp
4
62,23
Kaup on euroopa kesklaos. Tellimus tööpäeviti kell 17.00
Tellitav 1tp
26
75,69
Kaup on euroopa kesklaos. Tellimuse saadame 17.00
Lisainfo OE koodid Seotud sõidukid